Example 6-11 Actions for Con?¬?guration Files
RouterA# ccooppyy rruunnnniinngg--ccoonnffiigg:: ttffttpp::
Address or name of remote host []? 10.1.1.1
Destination filename [running-config]? wgroa.cfg
.!!
1684 bytes copied in 13.300 secs (129 bytes/sec)
RouterA# ccooppyy ttffttpp:: rruunnnniinngg--ccoonnffiigg::
Address or name of remote host []? 10.1.1.1
Source filename []? wgroa.cfg
Destination filename [running-config]?
Accessing tftp://10.1.1.1/wgroa.cfg...
Loading wgroa.cfg from 10.1.1.1 (via Ethernet0): !
[OK - 1684/3072 bytes]
1684 bytes copied in 17.692 secs (99 bytes/sec)
452 Chapter 6: Network Environment Management
Using show and debug Commands on Cisco Devices
The show and debug commands are built-in tools for troubleshooting. The show command
is used to display static information, while the debug command is used to display dynamic
data and events. Table 6-4 outlines the major differences in these commands.
The show and debug commands have the following functions:
?– show: To snapshot problems with interfaces, media, or network performance
?– debug: To check the ?¬‚ow of protocol traf?¬?c for problems, protocol bugs, or
miscon?¬?gurations
Table 6-5 describes the major differences between the show and debug commands.
Pages:
594
595
596
597
598
599
600
601
602
603
604
605
606
607
608
609
610
611
612
613
614
615
616
617
618